H743 60A FC ESC Flight Stack Fly Tower para sa Drone Fpv

• MCU: STM32H743VIH6, 480MHz , 1MB RAM, 2MB Flash
• Board V1.0 IMU: MPU6000 (SPI1) at ICM20602 (SPI4)
• Board V1.5 IMU: MPU6000 (SPI1) at ICM42605 (SPI4)
• Baro: Infineon DPS310 (I2C2)
• OSD: AT7456E (SPI2)
• Blackbox: MicroSD card socket (SDIO)
• 7x Uarts (1,2,3,4,6,7,8) na may built-in na inversion.
• 13x PWM output (kabilang ang 'LED' pad)
• 2x I2C
• 1x PWEDE
• 6x ADC (VBAT, Kasalukuyan, RSSI, Analog AirSpeed, Vbat2, Cur2)
• 3x LEDs para sa FC STATUS (Blue, Red) at 3.3V indicator(Red)
• 1x SPI3 breakout
• USB Type-C(USB2.0)
• 1x JST-SH1.0_8pin connector (Vbat/G/Curr/Rx8/S1/S2/S3/S4)
• 1x JST-GH1.25_4pin connector (5V/CAN-H/CAN-L/G)
• Switch ng Dual Camera Inputs
• 5V/Vbat filtered power ON/OFF switch
• Ang DJI FPV OSD ay sinusuportahan ng anumang ekstrang UART

• Vbat Input: 6~36V (2~8S LiPo)
• BEC: 5V 2A cont. (Max.3A)
• LDO 3.3V: Max.200mA
• Walang Kasalukuyang Sensor na built-in
• Sinusuportahan ng ADC Vbat2 pad ang Max. 69V (boltahe divider: 1K:20K)
• Static power: 200mA@5V na may Betaflight, 150mA@5V na may ArduPilot

• ArduPilot (ChiBiOS): MATEKH743
• BetaFlight: MATEKH743
• INAV: MATEKH743

• Pag-mount: 30.5 x 30.5mm, Φ4mm na may Grommets Φ3mm
• Mga sukat: 37 x 38 mm
• Timbang: 7g

• 1x H743-SLIM
• 6x Silicon grommets M4 hanggang M3
• 1x JST-SH1.0_8pin cable, 5cm
• 2x JST-SH1.0_8pin connector
• 1x JST-GH-4P hanggang JST-GH-4P cable para sa CAN port, 20cm

ESC:

Pag-mount: 30.5*30.5mm/M3

Sukat: 43*48.8mm